Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying Basic Interface Parameter Configurations
Procedure
- Run the display interface [ interface-type [ interface-number [.subinterface-number ] ] ] command to check information about an interface, including interface running status, basic interface configuration, and packet forwarding on the interface.
- Run the display interface brief [ main ] command to check brief information about interfaces, including the physical status, protocol status, bandwidth usage in the inbound and outbound directions during a specific period, and the number of error packets sent and received.
- Run the display ip interface [ interface-type interface-number [.subinterface-number ] ] command to check the IP configuration of an interface.
- Run the display interface description [ interface-type [ interface-number [.subinterface-number ] ] ] command to check the description of an interface.
- Run the display counters [ inbound | outbound ] [ interface interface-type [ interface-number [.subinterface-number ] ] ] [ nonzero ] command to check traffic statistics on a physical interface.
- Run the display counters rate [ inbound | outbound ] [ interface interface-type [ interface-number [.subinterface-number ] ] ] [ nonzero ] command to check the inbound and outbound traffic rates on an interface.
- Run the display interface [ interface-type ] counters { inbound | outbound } command to check statistics about packets received and transmitted on a physical interface.
- Run the display counters error [ inbound | outbound ] [ interface interface-type [ interface-number [.subinterface-number ] ] ] command to check error traffic statistics on an interface.
