- About This Document
Basic Configuration for Interfaces
Ethernet Interface Configuration
- Overview of Ethernet Interfaces
- Licensing Requirements and Limitations for Ethernet Interfaces
- Default Settings for Ethernet Interfaces
- Configuring ETH Management Interface Attributes
- Configuring Interfaces in a Batch
- Configuring Port Protection
Configuring the Rate and Mode
Configuring Common Attributes of Optical and Electrical Interfaces
- Configuring Bidirectional Flow Control
- Configuring Unidirectional Flow Control
- Setting the Minimum Interval for Re-enabling an Interface
- Configuring the Delay in Reporting Physical Status Changes
- Configuring the Interval of Collecting Traffic Statistics on an Interface
- Configuring Link Flapping Protection
- Configuring an Interface to Transit to the Error-Down State When the Number of Received Error Packets Exceeds the Threshold
- Configuring the IFG
- Configuring the Device to Count the IFG and Preamble Traffic Statistics
- Setting the Jumbo Frame Length Allowed on an Interface
- Configuring the MTU of an Interface
- Configuring the Log and Alarm Threshold for Inbound and Outbound Bandwidth Usage
- Configuring the Trap Threshold for a Sudden Traffic Volume Change on Interfaces
- Disabling Detection of a Sudden Broadcast Traffic Volume Change in the Inbound Direction of Interfaces
- Enabling the Log Function for Inbound and Outbound Packet Loss Caused by Congestion
Configuring Optical Interface Attributes
- Configuring an XGE Interface to Work in LAN/WAN Mode
- Configuring Interface Split and Merge
- Configuring Unidirectional Single-Fiber Communication
- Configuring the Training Function on a 40GE Interface
- Configuring the Training Function on a 100GE Interface
- Configuring an Interface to Transit to Error-Down State When the Optical Power Is Low
- Configuring the MDI Type of an Electrical Interface
Maintaining Ethernet Interfaces
Configuration Examples for Ethernet Interfaces
Troubleshooting Ethernet Interfaces
FAQ About Ethernet Interfaces
- How Can Two Interfaces at Both Ends of a Link Determine the Rate and Duplex Mode Through Auto-Negotiation?
- How Can Packet Loss Be Avoided When Two Interfaces at Both Ends of a Link Work in Auto-Negotiation Mode and Use the Half-Duplex Mode?
- What Are the Differences Between a Combo Interface and a Common Interface?
- Why Is a Non-Connected Interface Up?
- Can an IP Address Be Directly Assigned to a Physical Interface?
Logical Interface Configuration