Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring UDP Helper
Pre-configuration Tasks
Before configuring UDP helper, configure a reachable route from the switch to the destination server.
Procedure
- Run system-view
The system view is displayed.
- Run udp-helper enable
UDP helper is enabled.
- (Optional) Run udp-helper port { port-number | dns | netbios-ds | netbios-ns | tacacs | tftp | time }
The UDP destination port to which UDP broadcast packets are relayed is specified.
After UDP helper is enabled, the switch relays the UDP packets with the following destination ports by default: Time (37), TACACS (49), DNS (53), TFTP (69), NetBIOS-NS (137), and NetBIOS-DS (138). If the UDP destination port you want to specify is among the six ports, skip this step.
- Run interface interface-type interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
- Run udp-helper server ip-address
The destination server for UDP helper is specified.
