Enabling the ARP Module to Send ARP Vlink Direct Routes to the RM Module

Usage Scenario

ARP Vlink direct routes are 32-bit host routes that are generated based on ARP entries statically configured or dynamically learned on sub-interfaces or VLANIF interfaces. In most cases, ARP Vlink direct routes are only used to guide local forwarding. On an IPv4 network, a device can be configured to send ARP Vlink direct routes to precisely control downstream traffic and improve forwarding efficiency.

To control the scale and maintain the stability of a routing table, the ARP module does not send ARP Vlink direct routes to the route management (RM) module. In some scenarios, however, the device needs to perform operations based on specific routes of users. For example, the device needs to directly send the network traffic to specific user terminals, or route filtering is used to restrict inter-device communication.

Figure 2-17 shows an example.

Figure 2-17 Enabling the ARP module to send ARP Vlink direct routes to the RM module

In Figure 2-17, SwitchB connects to three users through the sub-interface. Based on service requirements, RouterD only needs to interconnect with RouterB, not RouterA or RouterC.

You can enable the ARP module to send ARP Vlink direct routes on SwitchB, and use the routing policy to filter out the network segment routes and the routes to RouterA and RouterC, and to reserve the ARP Vlink direct route to RouterB. This allows precise control on the traffic between RouterD and RouterB.

Pre-configuration Tasks

Before configuring the ARP module of a device to report ARP Vlink direct routes to the RM module, configure a sub-interface or VLANIF interface.

For more details about sub-interfaces, see Configuring an Ethernet Sub-interface in "Logical Interface Configuration" in the S7700 V200R019C10 Configuration Guide - Interface Management.