ACL Reference
This node is only available in the NAC unified and non-NETCONF modes.
Interface ACL
Procedure
- Choose Interface ACL tab, as shown in Figure 5-153. and click the
- Select a port to be configured. Perform the following operations as required in the port area:
- Click a port icon. To deselect the port, click the port icon again.
- Drag the cursor to select consecutive ports in a batch.
- Click multiple port icons to select these ports, and click a port icon again to deselect the port.
- Select a slot where an LPU is located. All ports on the LPU are selected.
- Configure the inbound and outbound ACL numbers.
- After setting the parameters, click Apply.
VLAN ACL
Procedure
- Choose VLAN ACL tab, as shown in Figure 5-155. and click the
- Click
next to VLAN ID to select VLAN ID.
- Configure the inbound and outbound VLAN ACL numbers.
- After setting the parameters, click Apply.