VRRP
IPv4
Procedure
- Create a VRRP entry.
- Choose to access the IPv4 page. Click Create, as shown in Figure 5-115.
Table 5-64 describes the parameters.
Table 5-64 VRRP parametersParameter
Description
VRID
Indicates the VRID of a VRRP group.
VLANIF
Click
to specify the VLANIF interface on which a VRRP group is created.
Virtual IP
Indicates the virtual IP address of a VRRP group. Clickto add the virtual IP address.
NOTE:The virtual IP address must be on the same network segment as the IP address of the VLANIF interface.
Configuration priority
Indicates the priority of a device in the VRRP group. A larger value indicates a higher priority.
Observing port
Indicates whether to enable association between VRRP and the interface status.
- ON: Association between VRRP and the interface status is enabled.
- OFF: Association between VRRP and the interface status is disabled.
Interface name
Click
to specify the associated interface.
NOTE:This parameter is available only when the value of Observing port is ON.
Priority
Indicates the value by which the priority of the associated interface increases or decreases. Click
to specify the value.
NOTE:This parameter is available only when the value of Observing port is ON.
- Choose to access the IPv4 page. Click Create, as shown in Figure 5-115.
- Modify a VRRP entry.
- Click Modify next to a data item to access the Modify VRRP page, as shown in Figure 5-116.
- Delete a VRRP entry.
- Choose to access the IPv4 page.
- Select a data item to be deleted and click Delete. In the dialog box that is displayed, click OK.
- Refresh VRRP information.
- Choose to access the IPv4 page.
- Click Refresh to refresh the VRRP list.
to specify the VLANIF interface on which a VRRP group is created.
to add the virtual IP address.
IPv6
Procedure
- Create a VRRP6 entry.
- Choose to access the IPv6 page. Click Create, as shown in Figure 5-117.
Table 5-65 describes the parameters.
Table 5-65 VRRP6 parametersParameter
Description
VRID
Indicates the VRID of a VRRP6 group.
VLANIF
Click
to specify the VLANIF interface on which a VRRP6 group is created.
Link local address
Indicates the link local address.
Virtual IP
Indicates the virtual IP address of a VRRP6 group. Clickto add the virtual IP address.
NOTE:The virtual IP address must be on the same network segment as the IP address of the VLANIF interface.
The first virtual IPv6 address of a VRRP6 group must be a link local address.
Configuration priority
Indicates the priority of a device in the VRRP6 group. A larger value indicates a higher priority.
- Choose to access the IPv6 page. Click Create, as shown in Figure 5-117.
- Modify a VRRP6 entry.
- Click Modify next to a data item to access the Modify VRRP6 page, as shown in Figure 5-118.
- Delete a VRRP6 entry.
- Choose to access the IPv6 page.
- Select a data item to be deleted and click Delete. In the dialog box that is displayed, click OK.
- Refresh VRRP6 information.
- Choose to access the IPv6 page.
- Click Refresh to refresh the VRRP6 list.
