Configuring a Device to Communicate with an NMS Through SNMPv2c

No relevant resource is found in the selected language.

Enterprise

Worldwide

- Türkçe

History
Popular search
Switches Routers Servers Storage Data Center Energy Cloud Computing
Quick access
Recommended

Support

Documentation

S12700 and S12700E V200R019C10 Configuration Guide - Network Management and Monitoring

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, TWAMP Light, NETCONF, eMDI, and Intelligent Video O&M.

Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).

Configuring a Device to Communicate with an NMS Through SNMPv2c

Context

To allow a device to communicate with an NMS through SNMPv2c, configure SNMPv2c on the device. The SNMP parameters must be configured on both the managed device (agent) and NMS. This section describes only the SNMP configurations on the agent side. For details about SNMP configurations on an NMS, see the NMS operation guide.

Pre-configuration Tasks

Before configuring a device to communicate with an NMS through SNMPv2c, configure a routing protocol to ensure that at least one route exists between the switch and NMS.

Configuration Procedure

When you configure a device to communicate with the NMS through SNMPv2c, only Configuring Basic SNMPv2c Functions is mandatory. The other steps are optional and can be performed in any sequence.

After the SNMP basic functions are configured, the switch and NMS can communicate with each other.

The NMS using the specified community name can access the ViewDefault view, in which the internet MIB (OID: 1.3.6.1) can be operated.
The managed device sends traps generated by the modules that are enabled by default to the NMS.

The following are optional SNMPv2c configurations to implement refined management:

To allow an NMS that uses a specified community name to manage specified objects on the device, perform the operations in Restricting Management Rights of the NMS.
To allow a specified module on the managed device to report traps to the NMS, perform the operations in Configuring the Trap/Inform Function.
To allow the device to send traps to the NMS periodically, perform the operations in Configuring the Device to Send Heartbeat Traps to the NMS.
To modify SNMP packet transmission parameters, perform the operations in Enhancing the Reliability for Transmitting SNMP Packets.
If the NMS and managed device are both Huawei products, perform the operations in Enabling the SNMP Extended Error Code Function so that the managed device can send more types of error codes. More error codes facilitate your fault location and rectification.

Translation

简体中文

Download

Updated: 2022-05-20

Document ID: EDOC1100126923

Downloads: 163

Average rating:

This Document Applies to these Products

Related Version

Digital Signature File

Digital Signature Authentication Mode

Previous Next

Enterprise

Huawei Cloud

Carrier

Consumer

Corporate