Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an NQA Test Instance
Pre-configuration Tasks
Before configuring the NQA test instance, complete the following tasks:
- Ensure that the device is running properly.
- Configure routing to ensure reachable routes between devices involved in the test.
The pre-configuration tasks differ from different test instances. For details, see the configuration of each test instance.
Configuration Procedure
The following optional test instances are independent of each other:
- Configuring a DNS Test Instance
- Configuring an FTP Download Test Instance
- Configuring an FTP Upload Test Instance
- Configuring an HTTP Test Instance
- Configuring an ICMP Test Instance
- Configuring an ICMP Jitter Test Instance
- Configuring an SNMP Test Instance
- Configuring a TCP Test Instance
- Configuring a Trace Test Instance
- Configuring a UDP Test Instance
- Configuring a UDP Jitter Test Instance
- Configuring a Path Jitter Test
- Configuring the MAC Ping Test
- Configuring the LSP Ping Test
- Configuring the LSP Jitter Test
- Configuring the LSP Trace Test
- Configuring the NQA MTrace Test to Check the RPF Path from the Multicast Source to the Querier
- Configuring the NQA MTrace Test to Check the Multicast Path from the Multicast Source to the Querier
- Configuring the NQA MTrace Test to Check the RPF Path from the Multicast Source to the Destination Host
- Configuring the NQA MTrace Test to Check the Multicast Path from the Multicast Source to the Destination Host
- Configuring a PWE3 Ping Test Instance on a Single-Hop PW
- Configuring a PWE3 Ping Test Instance on a Multi-Hop PW
- Configuring a PWE3 Trace Test Instance on a Single-Hop PW
- Configuring a PWE3 Trace Test Instance on a Multi-Hop PW
- Verifying the NQA Test Instance Configuration