Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between BFD Sessions
Procedure
- Run system-view
The system view is displayed.
- Run oam-mgr
The OAM management view is displayed.
- Run one of the following commands as required.
Run oam-bind ingress bfd-session bfd-session-id1 egress bfd-session bfd-session-id2
A BFD session is configured to report faults to a BFD session.
After a BFD session specified by bfd-session-id1 detects a fault, the BFD session reports faults to the BFD session specified by bfd-session-id2.
Run oam-bind bfd-session bfd-session-id1 bfd-session bfd-session-id2
BFD sessions are configured to report faults to each other.
If BFD sessions are configured to report faults to each other, the oam-bind ingress bfd-session bfd-session-id1 egress bfd-session bfd-session-id2 command in both directions will be displayed in the configuration file.