EMDI_MB
EMDI_MB_1.3.6.1.4.1.2011.5.25.227.2.1.58 hwEMDIIndicatorOverThreshold
Description
EMDI_MB/4/EMDI_TRAP_OVERTHRESHOLD:OID [oid] The monitor indicator of the EMDI instance exceeded the threshold in 3 consecutive periods.(EmdiInstId=[INTEGER], Type=[INTEGER], Value=[INTEGER], Threshold=[INTEGER]/100000)
A monitoring indicator detected by an eMDI instance exceeded the alarm threshold in three consecutive monitoring intervals.
Attribute
| Alarm ID | Alarm Severity | Alarm Type |
|---|---|---|
| 1.3.6.1.4.1.2011.5.25.227.2.1.58 | Warning | qualityOfServiceAlarm(3) |
Parameters
| Name | Meaning |
|---|---|
| OID | Indicates the MIB object ID of the alarm. |
| EmdiInstId | Indicates the eMDI instance ID. |
| Type | Indicates the eMDI alarm threshold type:
|
| Value | Indicates the value of an eMDI monitoring indicator. |
| Threshold | Indicates the eMDI alarm threshold. |
EMDI_MB_1.3.6.1.4.1.2011.5.25.227.2.1.59 hwEMDIIndicatorOverThresholdResume
Description
EMDI_MB/4/EMDI_TRAP_OVERTHRESHOLD_RESUME:OID [OID] The monitor indicator of the EMDI instance is lower than the threshold in 60 consecutive periods.(EmdiInstId=[INTEGER], Type=[INTEGER], Value=[INTEGER], Threshold=[INTEGER]/100000)
A monitoring indicator detected by an eMDI instance fell below the alarm threshold in 60 consecutive monitoring intervals.
Attribute
| Alarm ID | Alarm Severity | Alarm Type |
|---|---|---|
| 1.3.6.1.4.1.2011.5.25.227.2.1.59 | Warning | qualityOfServiceAlarm(3) |
Parameters
| Name | Meaning |
|---|---|
| oid | Indicates the MIB object ID of the alarm. |
| EmdiInstId | Indicates the eMDI instance ID. |
| Type | Indicates the eMDI alarm threshold type:
|
| Value | Indicates the value of an eMDI monitoring indicator. |
| Threshold | Indicates the eMDI alarm threshold. |
EMDI_MB_1.3.6.1.4.1.2011.5.25.227.2.1.60 hwEMDIReceiveDuplicatePackets
Description
EMDI_MB/4/EMDI_TRAP_RECVDUPLICATEPACKET:OID [OID] The device received duplicate packets in 3 consecutive periods.(EmdiInstId=[INTEGER])
The out-of-order packet rate detected by an eMDI instance was greater than the packet loss rate in three consecutive monitoring intervals, and multiple flows existed on the network.
Attribute
| Alarm ID | Alarm Severity | Alarm Type |
|---|---|---|
| 1.3.6.1.4.1.2011.5.25.227.2.1.60 | Warning | qualityOfServiceAlarm(3) |
Parameters
| Name | Meaning |
|---|---|
| OID | Indicates the MIB object ID of the alarm. |
| EmdiInstId | Indicates the eMDI instance ID. |
Possible Causes
Only a few parameter types were configured when the target flow was defined. As a result, the target flow range was large.
Procedure
- Configure more types of parameters to define target flows
more precisely. For example, specify the source and destination port
numbers to define the target flow.
- If the target flows to be monitored are transported over UDP, run the flow ipv4 udp command to configure the target UDP flows to be monitored by an eMDI instance.
- If the target flows to be monitored are transported over TCP, run the flow ipv4 tcp command to configure the target TCP flows to be monitored by an eMDI instance.
- If the alarm persists, collect alarm and configuration information, and contact technical support personnel.
EMDI_MB_1.3.6.1.4.1.2011.5.25.227.2.1.61 hwEMDIReceiveDuplicatePacketsResume
Description
EMDI_MB/4/EMDI_TRAP_RECVDUPPACKET_RESUME:OID [OID] The device didn't received duplicate packets again in 60 consecutive periods.(EmdiInstId=[INTEGER])
The out-of-order packet rate detected by an eMDI instance was less than the packet loss rate in 60 consecutive monitoring intervals, and the multi-flow alarm was cleared.
Attribute
| Alarm ID | Alarm Severity | Alarm Type |
|---|---|---|
| 1.3.6.1.4.1.2011.5.25.227.2.1.61 | Warning | qualityOfServiceAlarm(3) |
Parameters
| Name | Meaning |
|---|---|
| OID | Indicates the MIB object ID of the alarm. |
| EmdiInstId | Indicates the eMDI instance ID. |