Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Forcibly Specifying a Clock Source
Context
By default, the system uses the automatic clock source selection algorithm to determine the clock source to be traced. You can also forcibly specify the clock source to be traced based on the clock source quality.
In forcible mode:
- The clock synchronization function must be enabled on the clock source to be forcibly specified.
- The system clock enters the tracing state only when the clock source is normal and its SSM quality level is not DNU. Otherwise, the system clock enters the hold state.
- If the forcibly specified clock source becomes invalid, the system clock enters the hold state. After the forcibly specified clock source is recovered, the system clock re-traces the forcibly specified clock source. After the switch is restarted, it continues to work in forcible mode.
Procedure
- Run system-view
The system view is displayed.
- Run clock force source { ptp slot slot-id | interface interface-type interface-number }
The clock source to be traced is forcibly specified.
By default, the system uses the automatic clock source selection algorithm to determine the clock source to be traced.