Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an AS in Centralized Mode (Direct Configuration)
Context
Service configurations can be delivered to ASs through service profiles. Apart from this method, you can also run the direct-command command on the parent to deliver some service configurations directly to ASs.
For services that can be directly configured for a single AS, see Service Configuration Supported on an AS.
Procedure
- Run system-view
The system view is displayed.
- Run uni-mng
The uni-mng view is displayed.
- Run as name as-name
The AS view is displayed.
- Run direct-command view { system | interface-type interface-number | stack-port member-id/port-id } command command-text
A command is directly delivered to an AS.
Example
This example shows how to enable loopback detection on GE0/0/1 of AS1.
<HUAWEI> system-view [HUAWEI] uni-mng [HUAWEI-um] as name as1 [HUAWEI-um-as-as1] direct-command view gigabitethernet 0/0/1 command loopback-detect enable
Verifying the Configuration
- Run the display uni-mng commit-result as-direct-config command to check the configuration delivery result.
- Run the display uni-mng execute-failed-record as-direct-config as name as-name command to check execution failure records after the configuration is delivered to an AS.