Configuring the Device to Output Traps to a Terminal
Context
After traps are output to a user terminal, you can view traps on the user terminal (host from which you log in to the device through Telnet) to monitor device running.
Procedure
- Run system-view
The system view is displayed.
- Run info-center monitor channel { channel-number | channel-name }
A channel through which traps are output to a user terminal is specified.
By default, the device uses channel 1 to output traps to a user terminal.
- Run info-center source { module-name | default } channel { channel-number | channel-name } trap { state { off | on } | level severity } *
A rule for outputting traps to a channel is set.
By default, channel 1 is enabled to output traps and the lowest severity is debugging.
- Run quit
Return to the user view.
- Run terminal monitor
Display of logs, traps, and debugging message output is enabled on the user terminal.
By default, console display is enabled and terminal display is disabled.
- Run terminal trapping
Traps display is enabled on the user terminal.
By default, trap display is enabled on the user terminal.