Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Traps to the Trap Buffer
Procedure
- Run system-view
The system view is displayed.
- Run info-center trapbuffer
The device is enabled to output traps to the trap buffer.
By default, the device is enabled to output traps to the trap buffer.
- Run info-center trapbuffer channel { channel-number | channel-name }
The channel used by the device to output traps to the trap buffer is specified.
By default, the device uses channel 3 to output traps to the trap buffer.
- Run info-center source { module-name | default } channel { channel-number | channel-name } trap { state { off | on } | level severity } *
A rule for outputting traps to a channel is set.
By default, channel 3 is enabled to output traps and the lowest severity is debugging.
- (Optional) Run info-center trapbuffer size trapbuffer-size
The maximum number of traps in the trap buffer is set.
By default, the trap buffer can store a maximum of 256 traps.