- About This Document
Basic Configuration for Interfaces
Ethernet Interface Configuration
- Overview of Ethernet Interfaces
- Licensing Requirements and Limitations for Ethernet Interfaces
- Default Settings for Ethernet Interfaces
- Configuring MEth Management Interface Attributes
- Configuring Interfaces in a Batch
- Configuring Port Protection
Configuring the Rate and Mode
- Configuring Auto-Negotiation
- Configuring the Interface Rate
- Configuring the Duplex Mode
- Configuring the Card Interface Working Mode
- Changing the Working Mode of an Interface and Splitting the Interface
- Configuring the Serdes Mode of a MultiGE Interface
- Configuring the Working Mode of a 25GE Interface
- Configuring the Working Mode of a Combo Interface
- Switching an Interface Between Layer 2 and Layer 3 Modes
Configuring Common Attributes of Optical and Electrical Interfaces
- Configuring Bidirectional Flow Control
- Configuring Unidirectional Flow Control
- Configuring the Delay in Reporting Physical Status Changes
- Configuring the Interval of Collecting Traffic Statistics on an Interface
- Configuring Link Flapping Protection
- Configuring an Interface to Transit to the Error-Down State When the Number of Received Error Packets Exceeds the Threshold
- Configuring the Device to Count the IFG and Preamble Traffic Statistics
- Setting the Jumbo Frame Length Allowed on an Interface
- Configuring the MTU of an Interface
- Configuring the Log and Alarm Threshold for Inbound and Outbound Bandwidth Usage
- Configuring the Trap Threshold for a Sudden Traffic Volume Change on Interfaces
- Disabling Detection of a Sudden Broadcast Traffic Volume Change in the Inbound Direction of Interfaces
- Enabling the Log Function for Inbound and Outbound Packet Loss Caused by Congestion
Configuring Optical Interface Attributes
Configuring Electrical Interface Attributes
Maintaining Ethernet Interfaces
Configuration Examples for Ethernet Interfaces
Troubleshooting Ethernet Interfaces
FAQ About Ethernet Interfaces
- How Can Two Interfaces at Both Ends of a Link Determine the Rate and Duplex Mode Through Auto-Negotiation?
- How Can Packet Loss Be Avoided When Two Interfaces at Both Ends of a Link Work in Auto-Negotiation Mode and Use the Half-Duplex Mode?
- What Are the Differences Between a Combo Interface and a Common Interface?
- Why Is a Non-Connected Interface Up?
- Can an IP Address Be Directly Assigned to a Physical Interface?
Logical Interface Configuration