Configuring a Subscriber Queue

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface interface-type interface-number

   The interface view is displayed.

3. Run the following commands as required.

   • Run traffic-user-queue outbound acl { [ ipv6 ] { bas-acl | adv-acl | name acl-name } } pir pir-value [ flow-queue-profile flow-queue-profile-name | flow-mapping-profile flow-mapping-profile-name ] ^*

     The device is configured to shape packets in a subscriber queue matching a single ACL rule and to reference the flow queue and flow mapping profile to implement HQoS.

   • Run traffic-user-queue outbound acl { l2-acl | name acl-name } acl { bas-acl | adv-acl | name acl-name } pir pir-value [ flow-queue-profile flow-queue-profile-name | flow-mapping-profile flow-mapping-profile-name ] ^*

     The device is configured to shape packets in a subscriber queue matching both Layer 2 and Layer 3 ACL rules and to reference the flow queue and flow mapping profile to implement HQoS.

   • Run traffic-user-queue outbound acl { bas-acl | adv-acl | name acl-name } acl { l2–acl | name acl-name } pir pir-value [ flow-queue-profile flow-queue-profile-name | flow-mapping-profile flow-mapping-profile-name ] ^*

     The device is configured to shape packets in a subscriber queue matching both Layer 2 and Layer 3 ACL rules and to reference the flow queue and flow mapping profile to implement HQoS.

   The flow-mapping-profile flow-mapping-profile-name parameter is not supported on the S5731-S, S5731S-S, S5731-H, and S5731S-H.

4. (Optional) Configure service scheme-based authorization to re-mark the internal priorities of packets. You can configure the device to re-mark internal priorities based on a user ACL in an SAC profile. The device then schedules packets based on the re-marked priorities.
   1. Run sac-profile name profile-name

      An SAC profile is created and its view is displayed, or the view of an existing SAC profile is displayed.

      By default, no SAC profile is configured on the device.

   2. Run acl { ucl-number | name acl-name } remark local-precedence local-precedence-value

      The device is configured to re-mark internal priorities based on a user ACL in an SAC profile.

      By default, re-marking internal priorities based on a user ACL is not configured in an SAC profile.

   3. Run quit

      Return to the system view.

   4. Run aaa

      The AAA view is displayed.

   5. Run service-scheme service-scheme-name

      A service scheme is created and its view is displayed.

      By default, no service scheme is created on the device.

   6. Run sac-profile profile-name

      The SAC profile is bound to the service scheme.

   7. Run quit

      The AAA view is displayed.