Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing the PID Module
- Open the PID cabinet door and adjust the support bar.Figure 7-12 Adjusting a support bar
- Open the maintenance compartment door of the PID module, and remove the cover from the connection box.Figure 7-13 Removing the cover from a connection box
- Disconnect cables from the faulty PID module, and label the cables.
- Remove the pipe connector from the faulty PID module.
- Remove the faulty PID module.Figure 7-14 Removing a faulty PID module
- Install a new PID module.
- Open the maintenance compartment door of the PID module, and remove the cover from the connection box.
- Connect the removed cables to the new PID module based on the cable labels.
- Secure the pipe connector to the PID module.
- Reinstall the connection box cover and close the maintenance compartment door of the PID module.
- Retract the support bar and close the PID module cabinet door.
After ensuring that the PID module is powered on, set parameters by referring to the SmartLogger3000 User Manual.
