Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Selecting a Connection Mode
You can connect a peripheral cable to the SACU in common mode or through a tube based on site requirements.
- To prevent poor cable connection due to overstress caused by ground subsidence, you are advised to bend the cable inside the cabinet for a slack of 20–30 mm (0.79–1.18 in.) before connecting the cable to the appropriate port.
- If a cable has a jacket, ensure that the jacket is in the cabinet.
- This section describes how to connect a peripheral cable to the RS485/ETH/DC waterproof connector in common mode and through a tube, and provides a reference for connecting peripheral cables to other waterproof connectors.