Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the Mounting Bracket
A mounting bracket has four groups of tapped holes, each group containing four tapped holes. Mark any hole in each group based on site requirements and mark four holes in total. Two round holes are preferred to secure the mounting bracket.
Figure 4-2 Mounting bracket dimensions
![]()
Wall-mounted Installation
Avoid drilling holes into the water pipes and power cables buried in the wall.
- To prevent dust inhalation or contact with eyes, wear safety goggles and an anti-dust respirator when drilling holes.
- Wipe away any dust in or around the holes and measure the hole distances. If the holes are inaccurately positioned, drill holes again.
- Level the head of the expansion sleeve with the concrete wall after removing the bolt, spring washer, and flat washer. Otherwise, the mounting bracket will not be securely installed on the wall.
- Prepare expansion bolts (M12x60 stainless steel expansion bolts are recommended).
- Install a mounting bracket.Figure 4-3 Installing a mounting bracket
When determining the positions for drilling holes, level the hole positions using a level, and mark the positions using a marker.
Support-mounted Installation
- Obtain the M12x40 bolt assemblies from the packing case. (If the length does not meet the installation requirements, prepare M12 bolt assemblies by yourself and use them together with the supplied M12 nuts.)
- Install a mounting bracket.Figure 4-4 Installing a mounting bracket
When determining the positions for drilling holes, level the hole positions using a level, and mark the positions using a marker.
Pole-mounted Installation
- Prepare a pole-mounting bracket by yourself. You are advised to use M12 U-shaped bolts to secure the pole-mounting bracket.
- Install a mounting bracket.Figure 4-5 Installing a mounting bracket
Figures provided in this section are for reference only. The actual poles and pole-mounting brackets may vary.
