Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connection Through a Pipe
If you choose connection through a pipe, ensure that an appropriate cable and a pipe are available.
- Prepare an appropriate pipe based on the diameter of the cable holes at the bottom. It is recommended that the pipe specifications comply with the waterproof connector specifications. For example, for a 3/4 in. waterproof connector, a 3/4 in. pipe is recommended.
- The pipe appearance is for reference only. The actual pipe may vary. This is applicable to all other similar figures.
Figure 5-2 Pipe and diameter of cable holes at the bottom
![]()
(1) Nut |
(2) Fitting |
(3) Conduit |
- Remove the locking cap and plug from the waterproof connector, and remove the waterproof connector.
- Secure the pipe fitting using the nut delivered with the pipe.Figure 5-3 Installing a pipe fitting
- Route the cable through the pipe conduit and then the fitting, and connect the cable.
- Secure the pipe fitting to the conduit.
- Check that the cable is connected correctly and securely. Then take appropriate measures to ensure that the pipe conduit and fitting are secured reliably, and seal the cable hole using supplied firestop putty.
- Clear foreign matter from the cabinet.
