Logging In to the Atlas IES WebUI

Prerequisites

• Google Chrome 69 or later is required.
• HTTP is an insecure protocol. Use HTTPS for login.

Precautions

• To ensure system security, change the initial password as prompted upon the first login and periodically change the password.
• If you log in to the system for the first time after the firmware update, press F5 to refresh the page. After the login is successful, change the password as prompted.
• The system locks your account if you enter incorrect passwords for consecutive five times. You can log in again 5 minutes later.
• By default, the system timeout period is 15 minutes. If no operation is performed on the WebUI within 15 minutes, the login page is displayed.

Procedure

1. Connect cables and deploy the network environment.
   1. Use an Ethernet cable to connect the PC to the management network port (Port 1 or Port 2) of the AI edge station, or connect the PC to the management network port through a switch.
   2. Configure the network port IP address and subnet mask of the PC, so that the PC can access the AI edge station.

   You are advised to set the network port IP address of the PC and the management network port IP address of the AI edge station in the same network segment. If the IP addresses are not in the same network segment, configure a router to ensure that the PC can correctly communicate with the AI edge station.

2. Open your browser, enter https://XXX.XXX.XXX.XXX in the address box, and press Enter. The login page is displayed.
   • XXX.XXX.XXX.XXX indicates the IP address for accessing the Atlas IES WebUI. The default IP address of the Port 1 is 192.168.2.111, and the default IP address of the Port 2 is 192.168.3.111.
   • If a message indicating a security certificate problem of the website is displayed, click Continue to this website (not recommended).
   Figure 5-29 Logging in to the Atlas IES
   

3. Select a language.
   Figure 5-30 Selecting a language
   

4. Enter the username and password.
   • Default user name: admin
   • Default password: Huawei12#$

5. Click Log In.

   Non-initial login: After you click Log In, the Atlas IES home page is displayed.

6. Change the initial user name and password.
   • 1.0.0.SPC200 or later

     In the dialog box displayed for you to change the password, enter the new username, old password, new password, and confirm password, and click OK, as shown in Figure 5-31.

     Figure 5-31 Changing the initial user name and password
     
   • Earlier than 1.0.0.SPC200
     In the dialog box displayed for you to change the password, enter the new username, old password, new password, and confirm password, and click OK, as shown in Figure 5-32.

     If you click Change Later, you can change the password upon the next login to the Atlas 500 IES. For details, see Changing the Initial User Name and Password for the IES.

     Figure 5-32 Changing the initial user name and password
     

   Change the user password by following on-screen instructions.

   • The user name must contain 1 to 16 characters, including digits, uppercase letters, and lowercase letters.
   • Password complexity requirements:

     • Contains 8 to 20 characters.

     • Contains at least three types of the following characters:

       • Lowercase letters: a to z

       • Uppercase letters: A to Z

       • Digits: 0-9

       • Special characters `~!@#$%^&*()-_=+\|[{}];:'",<.>/?

     • Cannot be the same as the user name or user name in reverse order.

     • You cannot set the latest five passwords as the new password.

7. On the login page, enter the new user name and password again.
8. Click Log In.

   After the login is successful, the home page is displayed. The login user name is displayed in the upper right corner of the page.