Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting a Phoenix (Alarm) Connector
Procedure
- Wear an ESD wrist strap.
For details, see ESD Protection.
- Connect the Phoenix (alarm) connector to the Phoenix (alarm) connector port on the rear panel of the Atlas 500 AI edge station.
For details about the Phoenix (alarm) connector and port, see Table 2-3.
- Connect the other end of the cable to the peer device.Figure 5-17 Connecting a Phoenix (alarm) connector
