Checking the Atlas 500 AI edge station

Procedure

1. Check the indicator status.

   Observe the indicator status to determine whether the hardware of the Atlas 500 AI edge station is in the normal state.

   For details, see Indicators and Buttons on the Front Panel and Indicators and Buttons on the Rear Panel.

2. Check the Atlas 500 AI edge station.
   Check the Atlas 500 AI edge station using the IES WebUI.

   1. Log in to the IES over the WebUI. For details, see Logging In to the Atlas IES WebUI.

      Change the initial password upon the first login. For details, see Changing the Initial User Name and Password for the IES.

   2. Choose Maintenance on the main menu, and choose Firmware Update > System Firmware in the navigation tree to view the firmware version of the Atlas 500 AI edge station, as shown in Figure 5-34.

      Check whether the version of the Atlas 500 AI edge station meets the site requirements. Check whether the version is the same as the version (x.x.x.xxx) of the obtained software package (for example, A500-3000_A500-3010-ESP-FIRMWARE-Vx.x.x.xxx.zip). If the version does not meet the site requirement, upgrade the version to the specified version by referring to the Atlas 500 AI Edge Station Upgrade Guide (Models 3000, 3010).

      Figure 5-34 Viewing version information (WebUI)
      
   3. Choose Maintenance on the main menu, and choose Alarms in the navigation tree to view the health status of the Atlas 500 AI edge station, as shown in Figure 5-35.
      Figure 5-35 Viewing the health status (WebUI)
      
   4. If an alarm is displayed, clear the alarm by referring to the Atlas 500 Intelligent Edge System Alarm Handling (Models 3000, 3010).