Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Support-Mounted Installation
Procedure
- Determine the positions for drilling holes using the marking-off template, and then mark the positions with a marker.Figure 4-13 Determining hole positions
- Drill holes using a hammer drill.
You are advised to apply anti-rust paint on the hole positions for protection.
Figure 4-14 Drilling holes - Secure the mounting bracket.Figure 4-15 Secure the mounting bracket
Prepare bolt assemblies based on the hole diameter of the mounting bracket.
- (Optional) Install the locking screw for the DC switch.Figure 4-16 Installing a locking screw for the DC switch
- Install the SUN2000 on the mounting bracket.
- Tighten the bolt assemblies.Figure 4-17 Tightening bolt assemblies
- (Optional) Install an anti-theft lock.
- Prepare an anti-theft lock suitable for the lock hole diameter (Ф10 mm).
- An outdoor waterproof lock is recommended.
- Keep the key to the anti-theft lock.
Figure 4-18 Installing an anti-theft lock
