Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic Functions of MPLS LDP
You can build an MPLS network only after basic functions of MPLS LDP are configured.
Pre-configuration Tasks
Before configuring basic functions of MPLS LDP, configure static routes or an IGP to ensure that IP routes between LSRs are reachable.
Routing Information Protocol version 1 (RIP-1) cannot be used.
Configuration Procedure
Configure basic functions of MPLS LDP according to the following sequence.
- Configuring the LSR ID
- Enabling Global MPLS
- Enabling Global MPLS LDP
- Configuring LDP Sessions
- (Optional) Configuring LDP Session Protection
- (Optional) Configuring an LDP Transport Address
- (Optional) Configuring Timers for LDP Session
- (Optional) Configuring LDP Loop Detection
- (Optional) Configuring the LDP Label Policies
- (Optional) Disabling a Device from Distributing Labels to Remote Peers
- (Optional) Configuring a Policy for Triggering LDP LSP Establishment
- (Optional) Disabling LDP LSP Flapping Suppression
- (Optional) Disabling a Device from Forwarding Unknown TLVs
A local device can be disabled from forwarding unknown TLVs to peers. - Verifying the Configuration of Basic MPLS LDP Functions
