Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Link Aggregation in LACP Mode
- (Optional) Setting the Number of LAGs
- Creating a LAG
- Setting the Link Aggregation Mode to LACP
- Adding Member Interfaces to an Eth-Trunk
- (Optional) Setting the Upper and Lower Thresholds for the Number of Active Interfaces
- (Optional) Configuring the Weight of Load Balancing for a Member Interface
- (Optional) Configuring a Load Balancing Mode (CE12800)
- (Optional) Configuring a Load Balancing Mode (CE12800E)
- (Optional) Configuring an Eth-Trunk Load Balancing Mode for PPPoE Packets
- (Optional) Setting the LACP System Priority
- (Optional) Setting the LACP Interface Priority
- (Optional) Setting the LACP System ID and MAC Address in Layer 3 Mode
- (Optional) Configuring LACP Preemption
- (Optional) Setting the Timeout Interval for Receiving LACPDUs
- (Optional) Configuring an Eth-Trunk Member Interface in Force Up State
- (Optional) Enabling State Flapping Suppression on an Eth-Trunk
- Verifying the Link Aggregation Configuration