No relevant resource is found in the selected language.
Your browser version is too early. Some functions of the website may be unavailable. To obtain better user experience, upgrade the browser to the latest version.
CloudEngine 12800 and 12800E V200R019C10 Configuration Guide - Ethernet Switching
This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, M-LAG, VLAN, QinQ, VLAN mapping, GVRP, STP/RSTP, MSTP, VBST, ERPS (G.8032), LBDT, and Layer 2 protocol transparent transmission.
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing M-LAG Historical Fault Event Information
Clearing M-LAG Historical Fault Event Information
Context
Before you check causes of M-LAG faults within a certain period, clear the existing historical fault event information on the device.
The historical fault event information about M-LAG faults cannot be restored after being cleared. Confirm your operation before clearing the historical fault event information.
Procedure
Run the reset m-lag troubleshooting history command in the user view to clear historical fault event information about M-LAG faults.