Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Weight of Load Balancing for a Member Interface
Context
On an Eth-Trunk interface, you can load balance traffic among member interfaces according to the weights configured for the member interfaces.
The higher the weight of a member interface, the heavier the load over the member link. Therefore, you can configure a higher weight for a member interface so that the member link can carry a heavier load.
Procedure
- Run system-view
The system view is displayed.
- Run interface interface-type interface-number
The Eth-Trunk member interface view is displayed.
- Run distribute-weight weight-value
The load balancing weight is configured for the Eth-Trunk member interface.
The default weight of an Eth-Trunk member interface is 1.
The total weight of member interfaces in an Eth-Trunk cannot exceed the maximum number of member interfaces allowed.
- Run commit
The configuration is committed.