Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring M-LAG Through the Root Bridge
When the root bridge mode is used to configure M-LAG, the M-LAG master and backup devices must be used as root bridges and configured with the same bridge ID on the STP network so that the two devices are simulated into one root bridge. The M-LAG master and backup devices are not affected by the network topology change on the Layer 2 network.
- Configuring the Root Bridge and Bridge ID
- Configuring a DFS Group
- Configuring M-LAG Consistency Check
- Configuring an Interface as a Peer-link Interface
- Configuring an M-LAG Member Interface
- (Optional) Configuring the Dual-Active Gateway
- (Optional) Configuring the Interface Status When the Peer-Link Fails
- (Optional) Enabling Enhanced M-LAG Layer 3 Forwarding
- Verifying the Configuration of M-LAG Configured Through the Root Bridge