Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the CR-LSP Backup Configuration
Procedure
- Run the display mpls te tunnel-interface [ tunnel tunnel-number ] command to check information about the tunnel interface.
- Run the display mpls te hot-standby state { all [ verbose ] | interface tunnel interface-number } command to check information about the hot-standby status.
- Run the display mpls te tunnel [ destination ip-address ] [ lsp-id ingress-lsr-id session-id local-lsp-id ] [ lsr-role { all | egress | ingress | remote | transit } ] [ name tunnel-name ] [ { incoming-interface | interface | outgoing-interface } interface-type interface-number ] command to check CR-LSP information.