Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SR-MPLS TE
Context
SR-MPLS TE is implemented after an SR-MPLS TE tunnel is created and traffic is imported to the SR-MPLS TE tunnel. To deploy some reliability solutions, perform one or more of the following operations: adjusting the establishment of SR-MPLS TE LSP backup, configuring BFD for SR-MPLS TE tunnels, and configuring BFD for SR-MPLS TE LSPs.
- Configuring an SR-MPLS TE Tunnel
An SR-MPLS TE tunnel is configured on a forwarder and then is delegated to the controller for management. - Importing Traffic to an SR-MPLS TE Tunnel
- Configuring SR-MPLS TE LSP Backup
- Configuring Static BFD for SR-MPLS TE Tunnels
- Configuring Static BFD for SR-MPLS TE LSPs
- Configuring Dynamic BFD for SR-MPLS TE LSPs
- Configuring SBFD for SR-MPLS TE LSP
This section describes how to configure SBFD to detect SR-MPLS TE LSP faults. - Configuring SBFD for SR-MPLS TE Tunnel
This section describes how to configure SBFD to detect SR-MPLS TE tunnel faults. - Configuring an SR-MPLS TE Group to Implement Differentiated Services
- Configuring IS-IS TI-LFA FRR
This section describes how to configure IS-IS TI-LFA FRR. - Maintaining SR-MPLS TE
- Configuration Examples for SR-MPLS TE