Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Auto TE FRR
Auto TE FRR is a local protection technique and is used to protect a CR-LSP against link faults and node faults. Auto TE FRR does not need to be configured manually.
Pre-configuration Tasks
Before configuring auto TE FRR, complete the following task:![]()
- Configure a dynamic MPLS TE tunnel. For details, see Configuring a Dynamic MPLS TE Tunnel.
- Enable MPLS, MPLS TE and RSVP-TE in the system view and interface view of each node along a bypass tunnel.
- Enable CSPF on a PLR.
Perform the operation of Configuring Dynamic BFD for RSVP to implement fast switching at the millisecond level.