Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD for RSVP
When a Layer 2 device exists between a PLR and its downstream neighbors, configure dynamic BFD for RSVP to detect link faults between RSVP neighboring nodes.
Pre-configuration Tasks
Before adjusting establishment of an MPLS TE tunnel, complete the following task:
- Configure a dynamic MPLS TE tunnel. For details, see Configuring a Dynamic MPLS TE Tunnel.