Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Connectivity of the TE Tunnel
Procedure
- Run the ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m interval | -r reply-mode | -s packet-size | -t time-out | -v | -g ] * te tunnel interface-number [ hot-standby ] [ compatible-mode ] command to check the connectivity of the TE tunnel between the ingress and egress.
If hot-standby is configured, a hot-standby CR-LSP is checked.
- Run the tracert lsp [ -a source-ip | -exp exp-value | -h ttl-value | -r reply-mode | -t time-out | -g ] * te tunnel interface-number [ hot-standby ] [ compatible-mode ] [ detail ] command to trace the hops of a TE tunnel.
If the hot-standby parameter is specified, the hot-standby CR-LSP can be tested.