Performing Pre-check
Check the software installation and initial configuration to ensure that site requirements are met.
Checking Licenses
Log in to DeviceManager. Check whether licenses have been imported and contain the same basic or value-added features as you purchased.
- If licenses are not imported, import them by following instructions in "Initializing the Storage System" in the installation guide.
- If the licenses are different from those you purchased, contact Huawei technical support.
Checking Software Installation
Check whether required software is properly installed on the storage system and application server. Table 4-1 lists the check items and provides the check methods.
Check Item |
Description |
|---|---|
(Optional) iSCSI initiator NOTE:
iSCSI initiators are required only for iSCSI connections. |
For details about installing an iSCSI initiator, refer to "Configuring Connectivity" in Huawei SAN Storage Host Connectivity Guide for XXX. XXX represents a specific operating system, for example, Windows. NOTE:
|
|
(Optional) UltraPath NOTE:
|
For details about installing UltraPath, refer to the OceanStor UltraPath for XXX User Guide. XXX represents a specific operating system, for example, Windows. NOTE:
You can log in to Huawei's technical support website (https://support.huawei.com/enterprise/). In the search field, enter UltraPath, and select a path from the paths that are automatically displayed to go to the document page. Then click the Software Download tab, and search for and download your desired software files. |
Checking Initial Configuration
- Network connection status
Table 4-2 lists the check items and provides the check methods.
Category |
Check Item |
Check Method |
|---|---|---|
Connection between a maintenance terminal and a storage system |
Check whether the management network port on the storage system communicates with the maintenance terminal properly. |
In CLI of the maintenance terminal, run the following command:
If the maintenance terminal receives data packets from the management network port, the storage system and maintenance terminal communicate properly. If the maintenance terminal receives no data packets from the management network port, change the IP address of the management network port and try again. |
Connection between a storage system and an application server (using a Windows application server as an example) |
When an iSCSI front-end port on the storage system is used for connection, check whether the iSCSI front-end port communicates with the service network port on the application server properly. |
In CLI mode on the application server, run the following command:
If the application server receives data packets from the iSCSI front-end port, the storage system and application server communicate properly. If the application server receives no data packets from the iSCSI front-end port, replace the network cable, change the IP address of the iSCSI front-end port, or add a route between the iSCSI front-end port and service network port, and try again. For details about how to change the IP address of an iSCSI front-end port or add a route between an iSCSI front-end port and a service network port, see the DeviceManager online help. |