Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the Mounting Bracket
Installation Precautions
Figure 4-7 shows the inverter mounting bracket dimensions.
The inverter mounting bracket has four groups of tapped holes, each group containing four tapped holes. Mark any hole in each group based on site requirements and mark four holes in total. The two round holes are recommended.
Before installing the mounting bracket, remove the security torx wrench from the mounting bracket and set it aside.
Figure 4-8 Removing a security torx wrench
![]()
