Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Chassis Cover
Removing the Chassis Cover
- Wear an ESD wrist strap. For details, see ESD Protection.
- Power off the device. For details, see Powering Off the Server.
- Remove the power cables and all signal cables.
- Remove the device. For details, see Removing the Device and Guide Rails.
- Loosen the handle screw of the cover using a Phillips screwdriver. See (1) in Figure 5-35.
- Pull out the handle to push the chassis cover backwards. See (2) in Figure 5-35.
- Lift the chassis cover. See (3) in Figure 5-35.
Installing the Chassis Cover
- Position the cover horizontally, align it with the fixing slots on both side panels of the chassis, and close the handle. See (1) and (2) in Figure 5-36.
- Tighten the screw using a Phillips screwdriver to secure the handle. See (3) in Figure 5-36.
- Install the device. For details, see Installing the Device and Guide Rails.
- Connect the power cables and all signal cables.
- Power on the device. For details, see Powering On the Server.
