Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PCIe RAID Controller Card
Removing a PCIe RAID Controller Card
- Wear an ESD wrist strap. For details, see ESD Protection.
- Power off the device. For details, see Powering Off the Server.
- Remove the power cables and all signal cables.
- Remove the device. For details, see Removing the Device and Guide Rails.
- Remove the chassis cover. For details, see Chassis Cover.
- Remove the air duct and support beam. For details, see Air Duct and Support Beam.
- Determine the position of the PCIe RAID controller card on the mainboard. See Figure 5-71. The PCIe RAID controller card is installed on riser module 1.
- Hold down the latches on the cables to the PCIe RAID controller card, and remove the cables from the PCIe RAID controller card. For details, see Internal Cabling.
- Remove the riser module 1. For details, see Riser Modules.
- Open the latch on the PCIe RAID controller card. See (1) in Figure 5-72.
- Remove the PCIe RAID controller card. See (2) in Figure 5-72.
- Place the removed PCIe RAID controller card in an ESD bag.
Installing a PCIe RAID Controller Card
- Take a spare PCIe RAID controller card out of its ESD bag.
- Insert the RAID controller card into a PCIe slot. See (1) in Figure 5-73.
- Close the latch. See (2) in Figure 5-73.
- Install the riser module 1. For details, see Riser Modules.
- Connect cables to the PCIe RAID controller card. For details, see Internal Cabling.
- Install the air duct and support beam. For details, see Air Duct and Support Beam.
- Install the chassis cover. For details, see Chassis Cover.
- Install the device. For details, see Installing the Device and Guide Rails.
- Connect the power cables and all signal cables.
- Power on the device. For details, see Powering On the Server.
- Log in to the iBMC WebUI, and check whether the new component is normal. For details, see the Atlas 800 AI Training Server iBMC Alarm Handling (Models 9000).
