Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DIMMs
Removing a DIMM
- Wear an ESD wrist strap. For details, see ESD Protection.
- Power off the device. For details, see Powering Off the Server.
- Remove the power cables and all signal cables.
- Remove the device. For details, see Removing the Device and Guide Rails.
- Remove the chassis cover. For details, see Chassis Cover.
- Remove the air duct and support beam. For details, see Air Duct and Support Beam.
- Simultaneously press the ejectors outwards. See (1) in Figure 5-44.
- Remove the DIMM from the slot. See (2) in Figure 5-44.
- Place the removed DIMM in the DIMM box.
Installing a DIMM
- Take a spare DIMM out of the DIMM box.
- Open the two fixing clips of the DIMM slot. See Figure 5-45.
- Align the DIMM with the DIMM slot, and insert the DIMM into the slot. See Figure 5-46.
The two retaining clips pop up into place automatically.
Do not touch the edge connector on a DIMM with bare hands. Before inserting a DIMM, ensure that the edge connector is not polluted.
- Install the air duct and support beam. For details, see Air Duct and Support Beam.
- Install the chassis cover. For details, see Chassis Cover.
- Install the device. For details, see Installing the Device and Guide Rails.
- Connect the power cables and all signal cables.
- Power on the device. For details, see Powering On the Server.
- Log in to the iBMC WebUI, and check whether the new component is normal. For details, see the Atlas 800 AI Training Server iBMC Alarm Handling (Models 9000).
