Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Battery
Removing the Battery
- Wear an ESD wrist strap. For details, see ESD Protection.
- Power off the device. For details, see Powering Off the Server.
- Remove the power cables and all signal cables.
- Remove the device. For details, see Removing the Device and Guide Rails.
- Remove the chassis cover. For details, see Chassis Cover.
- Remove the air duct and support beam. For details, see Air Duct and Support Beam.
- Pull up the right end of the battery and remove it from the slot. See Figure 5-47.
- Place the removed battery in an ESD bag.
Installing the Battery
- Take a spare battery out of its ESD bag.
- Hold the battery with the side marked with text facing upwards, insert the left end of the battery into the slot, and gently press down the battery until it is properly installed in the slot. See Figure 5-48.
- Install the air duct and support beam. For details, see Air Duct and Support Beam.
- Install the chassis cover. For details, see Chassis Cover.
- Install the device. For details, see Installing the Device and Guide Rails.
- Connect the power cables and all signal cables.
- Power on the device. For details, see Powering On the Server.
