Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Examples for Bit-Error-Triggered Protection Switching
This chapter provides configuration examples of bit-error-triggered protection switching.
- Example for Configuring Bit-Error-Triggered Section Switching
This section provides an example for configuring bit-error-triggered section switching. - Example for Configuring the Association Between Bit Errors and IGP Routes
- Example for Configuring Bit-Error-Triggered Trunk Update
This section provides an example for configuring bit-error-triggered trunk update. - Example for Configuring Bit-Error-Triggered RSVP-TE Tunnel Switching
This section provides an example for configuring bit-error-triggered Resource Reservation Protocol-Traffic Engineering (RSVP-TE) tunnel switching. - Example for Configuring Bit-Error-Triggered PW Switching
This section provides an example for configuring bit-error-triggered pseudo wire (PW) switching. - Example for Configuring Bit-Error-Triggered L3VPN Route Switching
This section provides an example for configuring bit-error-triggered Layer 3 virtual private network (L3VPN) route switching. - Example for Configuring Bit-Error-Triggered EVPN L3VPN Route Switching
This section provides an example for configuring bit-error-triggered EVPN L3VPN route switching. - Example for Configuring Bit-Error-Triggered Protection Switching on an NG MVPN
This section provides an example for configuring bit-error-triggered protection switching in an NG MVPN scenario. - Example for Associating MAC-Layer SD Alarms with E-PW APS
In E-PW APS scenarios, MPLS-TP OAM is used to monitor the status of a static single-segment (SS) PW. An E-Trunk is configured to determine the master/backup PE status. This section provides an example for associating MAC-layer SD alarms with E-PW APS.
