Maintaining Y.1731
This section describes how to clear Y.1731 statistics by maintaining Y.1731.
Clearing Y.1731 Statistics
Before collecting statistics about Y.1731 packets within a specified period, you must clear the original statistics.
Context
Y.1731 statistics cannot be restored after being cleared. Exercise caution when clearing Y.1731 statistics.
Procedure
- Clear statistics about point-to-multipoint single-ended frame loss measurement.
Run the reset y1731 statistic-type single-loss test-id test-id command in the user view.
- Clear statistics about point-to-multipoint two-way frame delay measurement.
Run the reset y1731 statistic-type twoway-delay test-id test-id command in the user view.
- Clear statistics about point-to-multipoint one-way frame delay measurement.
Run the reset y1731 statistic-type oneway-delay test-id test-id command in the user view.
- Clear statistics about point-to-multipoint single-ended SLM.
Run the reset y1731 statistic-type single-ended-synthetic test-id test-id command in the user view.
- Run commit
The configuration is committed.
Deleting Y.1731 ETH-Test Statistics
Before collecting statistics about Y.1731 ETH-test packets within a specified period of time, delete existing statistics.
Context
Procedure
- Delete Y.1731 ETH-test statistics on the MEP that initiates an ETH-test instance.
Run the reset y1731 eth-test md md-name ma ma-name mep mep-id command in the user view.
- Delete Y.1731 ETH-test statistics on the MEP that receives ETH-test packets.
Run the reset y1731 statistic-type eth-test md md-name ma ma-name mep mep-id command in the user view.
- Run commit
The configuration is committed.
