Front Panel Indicators and Buttons

Fault diagnostic LED

• ---: The server is operating normally.
• Error code: A server component is faulty.

For details about error code, see Atlas 800 AI Training Server iBMC (V3.01.00.00 or Later) Alarm Handling (Model 9010).

Power button/indicator

Power indicator

• Steady yellow: The server is in the standby state.
• Steady green: The server is properly powered on.

• Blinking yellow: The iBMC is starting.
• Off: The server is not connected to a power source.

Power button

• When the server is powered on, you can press this button to shut down the OS.
• When the server is powered on, you can hold down this button for 6 seconds to force the server to power off.
• When the server is in the standby state, you can press this button to start the server.

UID button/indicator

The UID button/indicator helps identify and locate a device.

UID indicator:

• Off: The device is not being located.

• Blinking blue (blinking 255 seconds): The device has been located and is differentiated from other devices that have also been located.

• Steady blue: The device is being located.

UID button:

• You can turn on, turn off, or blink the UID indicator by pressing the UID button on the panel or by using the iBMC CLI or WebUI.
• You can press this button to turn on or off the UID indicator.
• You can press and hold down this button for about 5 seconds to reset the iBMC.

Health indicator

• Steady green: The server is operating properly.
• Blinking red at 1 Hz: A major alarm has been generated on the server.
• Blinking red at 5 Hz: A critical alarm has been generated on the server.

Fan module indicator

• Off: The fan module is not powered on.
• Steady green: The fan modules are operating properly.
• Blinking red: An alarm is generated for a fan module.