Figure 2-9 shows the indicators on the rear panel of an Atlas 800 AI training server (model 9010).
Figure 2-9 Rear panel indicators![]()
1
|
Optical port transmission rate indicator
|
2
|
Optical port connection status indicator/data transmission status indicator
|
3
|
Management network port data transmission status indicator
|
4
|
Management network port connection status indicator
|
5
|
UID indicator
|
6
|
PSU indicator
|
7
|
Optical port transmission rate indicator
|
8
|
Optical port connection status indicator/data transmission status indicator
|
Table 2-6 Indicators on the rear panelIndicator
|
State Description
|
|---|
Management network port
|
Data transmission status indicator
|
- Blinking yellow: Data is being transmitted.
- Off: No data is being transmitted.
|
Connection status indicator
|
- Steady green: The network port is properly connected.
- Off: The network port is not connected.
|
2 x 100 GE optical port
|
Transmission rate indicator
|
- Steady green: The data transmission rate is 100 Gbit/s.
- Off: The network port is not connected.
|
Connection status indicator
|
- Steady green: The network port is properly connected.
- Blinking green: Data is being transmitted.
- Off: The network port is not connected.
|
2 x 10 GE optical port
|
Transmission rate indicator
|
- Steady green: The data transmission rate is 10 Gbit/s.
- Steady yellow: The data transmission rate is lower than 10 Gbit/s.
- Off: The network port is not connected.
|
Connection status indicator
|
- Steady green: The network port is properly connected.
- Blinking green: Data is being transmitted.
- Off: The network port is not connected.
|
UID indicator
|
The UID indicator helps identify and locate a device.
- Off: The device is not being located.
- Blinking blue (blinking 255 seconds): The device has been located and is differentiated from other devices that have also been located.
- Steady blue: The device is being located.
NOTE: You can turn on, turn off, or blink the UID indicator by pressing the UID button or remotely running a command on the iBMC CLI.
|
PSU indicator
|
- Steady green: The power input and output are normal.
- Steady orange: The input is normal, but no power output is supplied.
NOTE: The possible causes of no power output are as follows:
- Power supply overtemperature protection
- Power output overcurrent or short-circuit
- Output overvoltage
- Short-circuit protection
- Device failure (excluding failure of all devices)
- Blinking green at 1 Hz:
- Blinking green at 4 Hz: The firmware is being upgraded online.
NOTE: If the upgrade fails, the indicator turns orange 10 minutes later.
- Off: No power is supplied.
|
