Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting an Address for an Extra NTP Server (ntp -d extraserver)
Function
The ntp -d extraserver command is used to set an address for an extra NTP server.
Format
ipmcset -t ntp -d extraserver -v addr
Parameters
Parameter |
Description |
Value |
|---|---|---|
addr |
Specifies the address of the extra NTP server. |
The value can be any of the following:
NOTE:
The value 0.0.0.0 indicates that the address of the extra NTP server is deleted. |
Usage Guidelines
Linux and Windows NTP servers are supported.
Example
Set an extra NTP server with IP address of 192.168.2.2.
iBMC:/->ipmcset -t ntp -d extraserver -v 192.168.2.2
Set NTP extraserver server (192.168.2.2) successfully.
# Query NTP information.
iBMC:/->ipmcget -d ntpinfo
Status : enabled
Mode : manual
Preferred Server : dhcp1.com
Alternative Server : fc00::1234
Extra Server : 192.168.2.2
Synchronize : successful
Auth Enable : enabled
Group Key : imported