Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Failed to Connect to the Management System After the KVM Is Open
Symptom
Symptom |
Possible Causes |
|---|---|
After the KVM is open, "Failed to connect to the management system. The management system IP address is xx.xx.xx.xx." |
The default port number of the KVM service is 2198. This error occurs when the KVM service port is not enabled or is unavailable. |
Solution
- On the iBMC WebUI, choose Services > Port Services, and check whether the KVM service is enabled.
- Open the CLI (by using the cmd command), and run the telnet command, for example telnet xx.xx.xx.xx 2198, to check whether the KVM service port is reachable.
xx.xx.xx.xx indicates the IP address, and 2198 indicates the default KVM port No. Use the actual KVM port No. obtained in 1.
- Enable the KVM service, and connect to the KVM. Then, check whether the problem is resolved.
- If yes, no further action is required.
- If no, go to 2.
- Contact the network administrator to enable the port required for the KVM. After checking that the port is reachable, connect to the KVM and check whether the problem is resolved.
- If yes, no further action is required.
- If no, go to 5.
- Contact technical support.