Setting the SNMP Trap Community Name (trap -d community)

Enterprise

Worldwide

Function

The trap -d community command is used to set the SNMP trap community name.

ipmcset -t trap -d community

Parameter	Description	Value
Community	Specifies the SNMP trap community string.	The value range varies depending on whether password complexity check is enabled. If password complexity check is disabled, the value is a string of 1 to 18 characters consisting of letters, digits, and special characters (excluding spaces). If password complexity check is enabled, the value must meet the following requirements: Contain 8 to 18 characters Contain at least two of the following: uppercase letters A to Z, lowercase letters a to z, digits 0 to 9 Contain at least one of the following special characters: `~!@#$%^&*()-_=+\\|[{}];:'",<.>/? Cannot contain spaces.

Parameter

Description

Value

Community

Specifies the SNMP trap community string.

The value range varies depending on whether password complexity check is enabled.

If password complexity check is disabled, the value is a string of 1 to 18 characters consisting of letters, digits, and special characters (excluding spaces).
If password complexity check is enabled, the value must meet the following requirements:
- Contain 8 to 18 characters
- Contain at least two of the following: uppercase letters A to Z, lowercase letters a to z, digits 0 to 9
- Contain at least one of the following special characters: `~!@#$%^&*()-_=+\|[{}];:'",<.>/?
- Cannot contain spaces.

None

# Set the SNMP trap community name to mytrap.

iBMC:/->ipmcset -t trap -d community
New Community: 
Confirm Community: 
Set SNMP trap community successfully.