Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting NTP State (ntp -d status)
Function
The ntp -d status command is used to enable or disable the NTP function.
Format
ipmcset -t ntp -d status -v status
Parameters
Parameter |
Description |
Value |
|---|---|---|
status |
Specifies the NTP status. |
|
Usage Guidelines
None
Example
# Enable the NTP function.
iBMC:/->ipmcset -t ntp -d status -v enabled
Set NTP enable status (enabled) successfully.
# Query NTP information.
iBMC:/->ipmcget -d ntpinfo
Status : enabled
Mode : manual
Preferred Server : dhcp1.com
Alternative Server : fc00::1234
Extra Server : 192.168.2.2
Synchronize : successful
Auth Enable : enabled
Group Key : imported