Fan and Heat Dissipation

Air Inlet Temperature

Air inlet temperature data sampled every 10 minutes within the last one week.

Current Value

The latest temperature detected by the air inlet sensor.

Clear

Click Clear to clear all data.

Refresh

Click Refresh to update the current status to the statistics.

Basic information

Basic information about the fan modules of the server, including the slot number, name, model, speed, speed ratio and BOM Code of each fan module.

Energy saving mode

It is the default mode for the air cooled system.

Adjusts fans to the system load for better heat dissipation and power savings.

Low noise mode

Minimizes fan speed to dissipate heat quietly.

High performance mode

Maximizes fan speed for optimal component cooling and system running.

Custom mode

Provides interfaces for users to customize the following parameters. Optional value ranges will be given as references based on the server load and heat dissipation situation.

• CPU Target Temperature
• NPU HBM Target Temperature
• NPU AI Core Target Temperature
• Air Outlet Target Temperature
• Fan Speed

Liquid cooling mode

It is the default mode for the liquid cooled system.

Compared with the air cooling mode, the liquid cooling mode features lower initial fan speed, lower noise, and lower energy consumption without affecting system performance.

Custom mode

Allows users to set the fan speeds corresponding to different inlet temperature ranges.

• The Fan Speed parameters are available only when Custom mode is selected.
• The system provides the value range of Fan Speed based on the current load and heat dissipation of the server. Set this parameter based on the value range displayed.
• The fan speed corresponding to a higher temperature range must be greater than the fan speed corresponding to a lower temperature range.