Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Faults
Based on fault scenarios, ATC faults may be classified into the following types:
- Conversion failure due to operator unregistered to the operator prototype library
- Conversion failure due to operator engine not found
- Conversion failure caused by the default value of input_shape
- Conversion failure due to output nodes specified by out_nodes not found
- Conversion failure due to verification failure of out_nodes arguments
- Conversion failure due to node names specified by input_fp16_nodes not found
- Conversion failure due to infershape failure
- Conversion failure due to operator information library not found
- Conversion failure due to file path specified by insert_op_conf not found
- Conversion failure due to verification failure of AIPP configuration file specified by insert_op_conf
- Slow operating environment due to too large sizes or too many size choices of dynamic_image_size or dynamic_batch_size
- Missing operator in operator information library
